Communications - GE C30 Instruction Manual

PRODUCT SETUP
RESET UNAUTH ACCESS
Selected records can be cleared from user-programmable conditions with FlexLogic operands. Assigning user-
programmable pushbuttons to clear specific records is a typical application for these commands. Since the C30 responds
to rising edges of the configured FlexLogic operands, they must be asserted for at least 50 ms to take effect.
Clearing records with user-programmable operands is not protected by the command password. However, user-
programmable pushbuttons are protected by the command password. Thus, if they are used to clear records, the user-
programmable pushbuttons can provide extra security if required.
For example, to assign user-programmable pushbutton 1 to clear demand records, apply the following settings.
1. Assign the clear demand function to pushbutton 1 by making the following change in the
 CLEAR RELAY RECORDS
CLEAR DEMAND
2. Set the properties for user-programmable pushbutton 1 by making the following changes in the
SETUP  USER-PROGRAMMABLE PUSHBUTTONS  USER PUSHBUTTON 1
PUSHBUTTON 1 FUNCTION
PUSHBTN 1 DROP-OUT TIME

5.3.5 Communications

5
5.3.5.1 Menu
SETTINGS  PRODUCT SETUP  COMMUNICATIONS
 COMMUNICATIONS

5-36
RESET UNAUTH ACCESS:

Off
CLEAR DIR I/O STATS:

Off
— Resets the access restriction counter.
menu:
: " "
PUSHBUTTON 1 ON
: "Self-reset"
: "0.20 s"
 SERIAL PORTS


 NETWORK


 IPv4 ROUTE TABLE


 MODBUS PROTOCOL


 PROTOCOL


 DNP PROTOCOL


 DNP / IEC104

 POINT LISTS
 IEC 61850 PROTOCOL


 WEB SERVER

 HTTP PROTOCOL
 TFTP PROTOCOL


 IEC 60870-5-104

 PROTOCOL
CHAPTER 5: SETTINGS
Range: FlexLogic operand
Range: FlexLogic operand
Visible only for units with Direct I/O module
SETTINGS  PRODUCT SETUP
SETTINGS  PRODUCT
menu:
See below
See page 5-40
See page 5-43
See page 5-45
See page 5-46
See page 5-47
See page 5-50
Access in EnerVista
See page 5-51
See page 5-94
See page 5-95
See page 5-95
C30 CONTROLLER SYSTEM – INSTRUCTION MANUAL