GE C30 Instruction Manual page 237

Controller system
Hide thumbs Also See for C30:
Table of Contents

Advertisement

CHAPTER 5: SETTINGS
5.3.5.7 IPv4 route table
SETTINGS  PRODUCT SETUP  COMMUNICATIONS  IPv4 ROUTE TABLE 1(6)
 IPv4 ROUTE TABLE
A default route and up to six static routes can be configured.
The default route is used as the last choice when no other route towards a given destination is found.
 DEFAULT IPv4 ROUTE
 IPv4 NETWORK
 ROUTE 1
Configure the network IP and subnet settings before configuring the routing settings.
Add and delete static routes
Host routes are not supported at present.
The routing table configuration is available on the serial port and front panel. This is a deliberate decision, to avoid loss of
connectivity when remotely configuring the C30.
By default, the value of the destination field is 127.0.0.1 for all static routes (1 to 6). This is equivalent to saying that the
static routes are not configured. When the destination address is 127.0.0.1, the mask and gateway also must be kept on
default values.
By default, the value of the route gateway address is 127.0.0.1. This means that the default route is not configured.
To add a route:
1.
Use any of the static network route entries numbered 1 to 6 to configure a static network route. Once a route
destination is configured for any of the entries 1 to 6, that entry becomes a static route and it must meet all the rules
listed in the next section, General Conditions to be Satisfied by Static Routes.
2.
To configure the default route, enter a default gateway address. Once a default gateway address is configured, it
must be validated against condition 2 of the General Conditions to be Satisfied by Static Routes, where the route
gateway must be on a connected network.
To delete a route:
1.
Replace the route destination with the default loopback address of 127.0.0.1. When deleting a route, the mask and
gateway also must be brought back to default values.
2.
Delete the default route by replacing the default gateway with the default value of 127.0.0.1.
General conditions to be satisfied by static routes
The following rules are validated internally:
C30 CONTROLLER SYSTEM – INSTRUCTION MANUAL
 DEFAULT IPv4 ROUTE
 IPv4 NETWORK
 ROUTE 1
 IPv4 NETWORK
 ROUTE 6
GATEWAY ADDRESS:
127.0.0.1
RT1 DESTINATION:
127.0.0.1
RT1 NET MASK:
255.0.0.0
RT1 GATEWAY:
127.0.0.1
Range: standard IPV4 unicast address format
Range: standard IPV4 address format
Range: standard IPV4 subnet mask format
Range: standard IPV4 unicast address format
PRODUCT SETUP
5
5-43

Advertisement

Table of Contents
loading

Table of Contents