Transducer Inputs/Outputs - GE C30 Instruction Manual

TRANSDUCER INPUTS/OUTPUTS

on both channels (teleprotection outputs at the sending end or corresponding teleprotection inputs at the receiving end).
On three-terminal two-channel systems, redundancy is achieved by programming signal re-transmittal in the case of
channel failure between any pair of relays.
5
5.9 Transducer inputs/outputs
5.9.1 DCmA inputs
SETTINGS  TRANSDUCER I/O  DCMA INPUTS  DCMA INPUT F1(W8)
 DCMA INPUT F1

The C30 is provided with optional DCmA capability. This feature is specified as an option at the time of
ordering. See the Order Codes section in chapter 2 for details.
5-196
Figure 5-103: Teleprotection input/output processing
DCMA INPUT F1

FUNCTION: Disabled
DCMA INPUT F1 ID:

DCMA Ip 1
DCMA INPUT F1

UNITS: μA
DCMA INPUT F1

RANGE: 0 to -1 mA
DCMA INPUT F1 MIN

VALUE: 0.000
DCMA INPUT F1 MAX

VALUE: 0.000
CHAPTER 5: SETTINGS
Range: Disabled, Enabled
Range: up to 20 alphanumeric characters
Range: six alphanumeric characters
Range: 0 to –1 mA, 0 to +1 mA, –1 to +1 mA, 0 to 5
mA, 0 to 10mA, 0 to 20 mA, 4 to 20 m
Range: –9999.999 to +9999.999 in steps of 0.001
Range: –9999.999 to +9999.999 in steps of 0.001
C30 CONTROLLER SYSTEM – INSTRUCTION MANUAL