Drain Connection (Optional) - Gilson PIPETMAX 268 User Manual

2
Setup/Operation
HDMI
Not supported.
USB Device
The USB device port is used for communication between PIPETMAX and the tablet or PC.
A USB cable is provided as a standard accessory. Refer to the diagram on page 2-4 for the location of the USB device port.
Power Cord Connection
Use the power cord on the external power
supply to make the connection between the
power receptacle on PIPETMAX and the
external power supply.
The connection from the external power
supply to PIPETMAX uses a connector with a
locking collar. Check the alignment of the pins
and then push it in until it clicks and locks in
place. To disconnect, pull back on the locking
collar and then disconnect the cable from the
rear panel of PIPETMAX.
Locate the appropriate power cord for your line voltage and then make the connection between the external power supply and
the AC power source.

Drain Connection (Optional)

The PIPETMAX bed includes a drain. Optionally, connect a 1/8" NPT fitting and drain tubing. Ensure that the waste container is
lower than the bed of PIPETMAX.
drain
2-6 Gilson PIPETMAX® 268 User's Guide