TABLE OF CONTENTS Chapter 1 INTRODUCTION INTRODUCTION | 3 The Pipetting standard – Gilson's Parts Checklist | 3 PIPETMAN® Classic is designed and manufactured to provide you with a range of GlP Features | 3 robust, accurate, and precise pipettes.
±30 ≤8 ±40 ≤15 Each pipette is inspected and validated by qualified technicians in accordance with the P10Ml WITH D10Ml TIPs (P/N F161201) Gilson Quality system. Gilson declares that ≤6 ≤30 ±30 ±60 its manufactured pipettes comply with the ≤6 ≤30 ±30...
Pre-Rinse the Tips Dispense Place the end of the tip against the inside some liquids (e.g., protein-containing solutions wall of the recipient vessel (at an angle of 10° and organic solvents) can leave a film of liquid to 40°). on the inside wall of the tip; pre-rinse the tip to minimize any errors that may be related to this Press the push button slowly and smoothly phenomenon.
To make pipetting more comfortable and more ○ never lay the pipette on its side when secure, Gilson has developed several accessories: there is liquid in the tip. Pipette stands allow users to store pipettes If you use the same tip with a higher volume, vertically to avoid the possibility of liquid running pre-rinse the tip.
Cleaning and Decontamination Replace the tip on page 18. Please use the Damaged tip holder holder included safety bag to return the pipette to your local Gilson Service Replace both Center. Worn O-ring or seal parts Troubleshooting Table Use PIPETMAN...
The water level inside the tip should remain procedure available on the Gilson constant; if the level goes down, there is a website (www.gilson.com). If the leak.
You may remove the piston assembly for cleaning purposes only. If the piston assembly is changed, Piston the pipette must be adjusted and calibrated in a assembly Gilson authorized service Center. seal O-ring The piston assembly must not be NOTICE autoclaved.
You may refer to the bath (20 minutes at 50°C) or with a decontamination procedure soft-cloth and brushes. small round brushes available on the Gilson website NOTICE with soft plastic bristles may be used to (www.gilson.com). Liquid must clean the interior of the tip holder.
Chapter 7 Autoclaving The upper part (body) and the piston assembly SPARE PARTS of the pipette are not autoclavable. Only the following parts may be autoclaved: tip ejector, tip holder and connecting nut. The O-ring and ► service Kit 1st level includes: seal are not autoclavable;...
European Gilson’s sole liability under this warranty shall Directives for In Vitro Diagnostic Medical Devices be limited to, at Gilson’s sole option, repair or Directive (98/78/EC)*. replacement of any defective components of *Annex III, self-declared pipettes or refund of the purchase price paid for such pipettes.