Gilson PIPETMAX 268 User Manual page 40

Setup/Operation
Install Pipette Head(s)
Install the pipette head(s) on the upper pipette head assembly using the
thumb nuts. Ensure proper alignment of the pipette head against the upper
pipette head assembly before tightening the thumb nuts.
• If using only one pipette head, install a blank head on the other side.
Refer to the following instructions for how to convert the alignment
head into a blank head. The instructions describe how to convert it and
remove it; however, it can be converted while installed.
a) Push up to remove the bracket that is attached to alignment head.
b) Remove the thumb nuts securing the alignment head to the upper
pipette head assembly.
c) Pull down on the alignment pin to remove it.
d) Install the blank head on the upper pipette head assembly using the
thumb nuts.
• If a pipette head is already installed and needs to be removed, remove
the pipette head by removing the thumb nuts securing it to the upper
pipette head assembly.
Finish Tip Ejector Foot Installation
If using a MAX8x20 or MAX8x200 pipette head, skip to the next step
(Select Pipette Head Serial
Manually move the tip ejector foot down to the bottom, and while holding it
down, tighten the shoulder screw.
2-18
Number).
Gilson PIPETMAX® 268 User's Guide
2