Turn Sauna Control On And Off; Turn Sauna Control On; Turn Sauna Control Off - Fasel Elektronik FCU2000 Operating Manual

Operation
5.2

Turn sauna control on and off

5.2.1

Turn sauna control on

Ensure that the heater, the surroundings and the sensors are free of objects.
1.
2.
3.
5.2.2

Turn sauna control off

18
NOTE!
The temperature and humidity values displayed on the control unit may
vary from that displayed on the thermometers and hygrometers
mounted additionally in the cabin. This may be because of the following
reasons:
Depending on the cabin, temperatures differences of up to 60K and dif-
ferences in the relative humidity of up to 40% can occur from the floor to
ceiling or from the heater to the opposite wall.
Analogue instruments are slower to react than the electronic measure-
ment and display system used in the control unit.
Turn on the sauna control using the "Control unit ON" key. → See page 11, Fig. 2
The set point temperature and the set point humidity (if necessary) of the mode last
selected are displayed. The green lamp of the last selected mode flashes.
Select mode according to chapter.5.2.3
PLEASE NOTE!
The electronic components can be damaged by repeated improper
turning off!
Therefore:
– Turn off the sauna control as described.
PLEASE NOTE!
Cabin damage for e.g. mould growth due to premature stopping of
the drying function!
After completion of the "sauna with humidity" mode, the cabin is auto-
matically dried for a certain time at a certain temperature. This drying
function is used to avoid cabin damage such as mould growth.
Therefore:
– Do not stop the drying function prematurely.
– The drying function may only be stopped if the cabin is subsequently
operated in "Sauna" mode.
– If the drying function is stopped accidentally, a message appears on
the display. Start the drying function again by following the instruc-
tions on the display.
Operating manual Sauna control FCU2x00/FCU3x00/FCU4x00 Version V 2.09