Adjust "Infrared" Mode (Only Fcu3400 And Fcu4400); Adjust The Set Point Temperature, Humidity, Heating- And Remaining Time - Fasel Elektronik FCU2000 Operating Manual

Operation
5.3.3

Adjust "Infrared" mode (only FCU3400 and FCU4400)

The control unit is turned on.
1.
2.
3.







Fig. 6: "Infrared" view (example)
5.4

Adjust the set point temperature, humidity, heating- and remaining time

The following example describes how to adjust the set point temperature.
The set point humidity, the heating time, the remaining heating time and the timer are
adjusted similarly.
Note the following points:
Heating time
The heating time is the operating time for
the selected mode.
The heating time can be adjusted if the
lamp next to the mode key flashes.
Table: 6 Heating time / remaining heating time
22
Press the key (infrared mode) if required
In the mode "Infrared" additionally the base temperature of the oven can be adjusted.
Press the key until the symbol
Press the key again (symbol
If you want to adjust the set point temperature, set point humidity, heating time, re-
maining heating time or the timer, the corresponding symbol must light up at the right
of the display. That is, the symbol "Temperature" should light up if you want to adjust
the temperature.
The set point humidity can be adjusted only for the "Sauna with humidity" mode.
The heating time and the remaining heating time use the same symbol. The value
which you adjust depends on the status of the lamp next to the mode key.
Operating manual Sauna control FCU2x00/FCU3x00/FCU4x00 Version V 2.09
(adjust temperature) lights up
lights up).


Remaining heating time
The remaining heating time is the re-
maining time when the mode is turned
on. The remaining heating time is re-
duced automatically.
The remaining heating time can be ad-
justed if the lamp next to the mode key
lights up.
The modified remaining heating time
does not change the programmed heat-
ing time.
