Light Settings (Only For Menu "Pro") - Fasel Elektronik FCU2000 Operating Manual

"Basic settings" menu
6.1.7

Light settings (only for menu "Pro")

In this menu you can set the time, when the light should go on and how long it should
stay on after the end of a mode.
1.
2.







Fig. 25: "Light settings" view (example)
3.
4.








Fig. 26: "Light settings – change mode" view (example)
5.
6.
7.
8.
9.
36
Press (basic settings)
Press the key until you see the following view:
Press the key.
Following view is displayed:
Select one of the following lines with the
– Light ON at start
– Light ON if bath ready
– Falling delay time x min
– Light OFF at drying
Note!
Only the option "light ON at start" or "light ON if bath ready" can be selected.
Press the key. Selected line is enabled.
Option "light ON upon starting" is enabled. Cursor flashes on the selected line.
Press the key. Check mark is set (option selected).
Press the key: Check mark is deleted (option not selected).
Press the key. The selection is saved.
Exit the menu using the
Operating manual Sauna control FCU2x00/FCU3x00/FCU4x00 Version V 2.09
key. The lamp next to the key must light up.




or




key or select the next line with the
key:
(→ point 7)
(→ point 11)
(→ point 15)
(→ point 18)
or key.

