Agilent Technologies 34945A User Manual page 71

• settle time - specifies the time allowed for the switch/attenuator operation
• verification - enables and disables electronic verification of the
• verification polarity - set the logic polarity of the expected switch position
Bank (Distribution Board) Configuration Window
The distribution board bank configuration window provides settings for the
individual banks on the 34945EXT.
These settings include:
• LED drive control - enables and disables the distribution board LED drives
• LED drive level - sets the amount of current which controls LED
• channel drive type - sets the current drive mode (TTL or Open Collector)
• Preset Bank - this command sets the bank configuration to conform to the
Agilent 34945A Microwave Switch/Attenuator Driver Module User's Guide
to complete.
programmed switch state.
indicator signal.
Figure 4-5. The Bank (Distribution Board) Configuration Window.
(LEDs not included) which reflect the position indicator states of the
connected switches or attenuators.
brightness.
for the specified channels.
switches supported by the distribution board installed. The programming
of any switch or attenuator must begin by presetting the bank.
Introduction to Programming
4
63