Diagnostic Suite; Instrument Setup - Interacoustics AC40 Instructions For Use Manual

AC40 Instructions for Use - EN Page 43

3.9 Diagnostic Suite

This section describes the data-transfer and hybrid mode (On-Line / PC-operated modes) supported by
the new AC40.

3.9.1 Instrument setup

The setup is similar to that described in the previous chapter for audiometric data transfer.
Important: Please be sure to selected the "AC40 (version 2)" (and not "AC40", which refers to the old
version).
PC controlled instrument: Unselect this if you want to run the AC40 as a standalone audiometer (i.e.
not as a hybrid audiometer) but still being connected to the Diagnostic Suite. When pressing Save
Session on the instrument, the session will automatically be transferred to the Diagnostic Suite. See
below section "Sync Mode".
Upload Print Logo and Audiogram Symbols to AC40: A logo for direct print outs can be transferred to
the AC40 using the "Up Print Logo" button. The symbol scheme used in the Diagnostic Suite can be
transferred to the AC40 (when viewing the build in audiogram) by using the "Upload Custom Symbols"
button. Please refer to the AC40 operational manual for info on how to change the symbol scheme on the
AC40.