Avaya BCM50 User Manual page 30

BCM50 System Start Up
5. Click on the Add button. Enter the following settings and click OK:
 From IP Address: Start of the range of IP Addresses to be issued to
DHCP clients
 To IP Address: End of the range of IP Addresses to be issued to
DHCP clients.
 Default Gateway: Gateway address for this range to use.
6. This range will be issued to DHCP clients, if the BCM is configured to
be a DHCP server.
Note: For full details concerning the registration and configuration of IP
Phones, refer to the IP Telephony Guide.
General Settings Screen Settings
Attribute
The DHCP Disabled
Server is Enabled - IP Phones
Only
Enabled - All Devices
IP domain name <alphanumeric
character string>
Primary DNS IP <IP Address, format
address 10.10.10.10>
Secondary DNS <IP Address, format
IP address 10.10.10.10>
WINS server <IP Address, format
address 10.10.10.10>
WINS node type <drop-down menu>
30
Value
Determines the functionality of the DHCP server.
Default: Enabled – IP Phones Only
The domain name of the network.
The IP address of the primary DNS to be used by DHCP
clients.
The IP address of the secondary DNS to be used by
DHCP clients.
The address of the Windows Internet Server, which
resolves IP addresses on a DHCP network.
The type of WINS node:




Description
B-node: The BCM first checks the HMHOSTS
cache, then uses broadcast for name registration
and resolution.
P-node:The BCM registers with a NetBIOS Name
server at startup.
M-node: Mixes B- and P-node. The BCM uses the
B-node method, and if that fails, uses the P-node
method.
H-node: Uses both B- and P-node methods. B-
NN40010-318 Issue 1.2 BCM50 Rls 6.0