Table of Contents
Advertisement
8 Software
1.
Disable MROI by setting MROI_Enable to False. This is mandatory otherwise setting the
MROI entries will be ignored.
2.
Set MROI_Index. In the first run it is set to 0 and then incremented in every run.
3.
Set MROI_Y to the starting row of the MROI.
4.
Set MROI_H to the height of the MROI.
5.
Proceed with step 2, incrementing the MROI_Index. If no more MROI should be set, then
run the steps 2 to 4 again (incrementing MROI_Index) but set MROI_H to 0.
6.
Enable MROI by setting MROI_Enable to True.
7.
Read the property MROI_Htot. Set the property Height (in category ImageFormatControl) to
the value of MROI_Htot. This is mandatory as this value is not automatically updated.
Example pseudo-code to set two MROI: The resulting total height of the example will be 400.
SetFeature('MROI_Enable', false);
SetFeature('MROI_Index', 0);
SetFeature('MROI_Y', 50);
SetFeature('MROI_H', 100);
SetFeature('MROI_Index', 1);
SetFeature('MROI_Y', 600);
SetFeature('MROI_H', 300);
SetFeature('MROI_Index', 2);
SetFeature('MROI_H', 0);
SetFeature('MROI_Enable', true);
int heightTot;
GetFeature('MROI_Htot', &heightTot);
SetFeature('Height', heightTot);
8.8 Permanent Parameter Storage / Factory Reset
The property UserSetSave (in category UserSetControl) stores the current camera settings in the
non-volatile flash memory. At power-up these values are loaded.
The property UserSetLoad (in category UserSetControl) overwrites the current camera settings
with the settings that are stored in the flash memory.
The command CameraHeadFactoryReset (in category PhotonfocusMain) restores the settings of the
camera head
The calibration values of the FPN calibration are not stored with UserSetSave. Use
the command Correction_SaveToFlash for this (see Correction_SaveToFlash).
.
112 of 139
MAN077 11/2017 V1.0
Advertisement
Table of Contents
