Photon Focus MV1-D1280-L01-1280-G2-12 User Manual page 51

AcquisitionMode
Continuous
SingleFrame
MultiFrame
SingleFrameRecording
SingleFrameReadout
ContinuousRecording
ContinousReadout
Table 5.3: AcquisitionMode and Trigger (Footnotes:
for high speed recording, the image burst memory should be used)
MAN077 11/2017 V1.0
After the command AcquisitionStart is executed:
Camera aquires image frames continuously. Acquisition can be
stopped by executing AcquisitionStop command.
Camera acquires one frame and acquisition stops.
Camera acquires n=AcquisitionFrameCount frames and acquisition
stops.
Camera saves one image on the on-board memory of the IP engine.
One image is acquired from the IP engine's on-board memory. The
image must have been saved in the SingleFrameRecording mode.
Camera continuosly saves images on the on-board memory of the
IP engine until the memory is full. The size of available on-board
1)
memory is 24 MB.
All Images that have been previously saved by the
ContinuousRecording mode are acquired from the IP engine's
on-board memory.
1)
Memory can be used to manage GigE image transfer,
5.2 Trigger and Strobe
51 of 139