Siemens SIMATIC RF310M Operating Instructions Manual page 56

Error messages of the SIMATIC RF310M application
General errors
General errors communicated by the read/write device are displayed as error code 101 to
131. These errors can occur with all functions.
Error
code
101
105
106
112
113
119
120
121
125
128
130
131
Open Com Port - 1
Interface
function
1
1
1
1
56
Error Meaning
message/display
No tag with selected Presence error, possible causes:
ID in field
•
•
•
Wrong command Parameterization error, possible causes:
•
•
•
Field error Air interface faulty
Memory write error The tag memory cannot be written, possible causes:
•
•
Tag address error Error in the specified memory address (access attempted to non-
existent or non-accessible memory areas).
Low buffer error Buffer overflow: Insufficient buffer available in the reader for saving
the command
Watchdog error Major system fault (hardware fault)
Reset parameter Parameter assignment error: faulty parameter in RESET command
error
Active command Previous command is still active
error
Antenna error The antenna is already switched off or on
Wrong telegram Incorrect number of characters in frame
length
Command break Internal program error: Running command cancelled by reset
error
Error Error message/display
code
1 invalid handle
2 SetCommState failed
3 Set CommMask failed
10 failed to turn on 5V
The active command was not carried out completely
The tag has left the field while the command is being processed
Communication fault between reader and tag
Unknown command
Incorrect parameter
Function not allowed
Hardware fault (memory faulty)
Memory write-protected (corresponding OTP area has already
been written)
Meaning
Invalid access number
Error when setting the port parameter
Error when setting the port parameter
Error when switching on the 5V power supply
Operating Instructions, 07/2007, J31069-D0191-U001-A1-7618
SIMATIC RF310M Mobile Reader