Address Setup - Siemens SIMATIC RF310M Operating Instructions Manual

Simatic sensors rfid systems mobile reader
Hide thumbs Also See for SIMATIC RF310M:
Table of Contents

Advertisement

6.7.3

Address Setup

The Address Setup function defines the call of the commands "Read/Write MDS".
Select "Extras > Address Setup" (or <ALT+X+A>) for this purpose. The following window
appears:
Figure 6-17
"Start Address and"
Under "Read / Write", you can choose the parameters "Length" and "End Address".
Start Address and
"Read / Write"
Under "Read / Write", you can choose the parameters "selected range" and "complete tag".
This setting refers to the default setting in the case of execution of a tag command.
Read/Write
SIMATIC RF310M Mobile Reader
Operating Instructions, 07/2007, J31069-D0191-U001-A1-7618
Address Setup
Parameters
Length
End address
Parameters
Selected
range
Complete tag
6.7 The functions in the "Extras" menu
Description
The tag address in the case of the command Read/Write is
entered via a start address and the length of the data to be
edited.
The tag address in the case of the Read/Write command is
entered via a start address and an end address.
Description
When reading/writing a tag, the currently active (previously
defined) range is always displayed as the range to be
read/written.
When reading/writing a tag, the entire tag is always edited.
The read/write function is started immediately. It is not
possible to enter a partial range of the tag.
SIMATIC RF310M software
45

Advertisement

Table of Contents
loading

Table of Contents