Vacon 100 Installation Manual page 22

vacon • 19
Error
number
0x06 Setting not permitted (may only be reset)
0x07 Description element cannot be changed
0x08 Reserved (not used)
0x09 No description data available
0x0A Reserved (not used)
0x0B No operation priority
0x0C...0x0E Reserved (not used)
0x0F No text array available
0x10 Reserved (not used)
0x11 Request cannot be executed
0x12...0x13 Reserved (not used)
0x14 Value impermissible
0x15 Response too long
0x16 Impermissible parameter address
0x17 Illegal format
0x18 Number of values are not consistent
0x19 Axis non-existent
0x20 Parameter text cannot be changed
0x21 Invalid request ID
0x22...0x64 Reserved (not used)
0x65 Invalid request reference
0x66 Invalid request ID
0x67 Reserved (not used)
0x68 Invalid number of parameters
0x69 Invalid attribute
0x6A Reserved (not used)
0x6B Request is too short
0x6C Reserved (not used)
0x6D Reserved (not used)
0x6E...0xFF Reserved (not used)
4
Table 15.
Meaning When used
Change request to non-zero value, where
this is not allowed.
Change request to a read-only parameter
description element.
Access to unavailable parameter
description.
Change request without access rights to
perform the change.
Access to unavailable parameter text
array.
Access is temporarily not possible due to
unspecified reasons.
Change request with a value within the
allowed range, but is otherwise not
permissible.
The length of the respose exceeds the
maximum transmittable length.
Error in the parameter address field.
Illegal format was provided in write
request.
Number of values in the write request does
not match the number of values in the
parameter.
Access to non-existent axis number
Change request to unavailable parameter
text.
If a parameter request does not have the
request ID 01h or 02h, this error code is
returned.
Unallowed value for request reference.
Unallowed value in request ID (not Request
Parameter nor Change Parameter).
Invalid number of parameters in request (0
or greater than 39).
Invalid attribute specified in request.
Not enough parameter value data was
transmitted in a Change request.
Alternatively, the request did not contain a
complete parameter address.
Tel. +358 (0) 201 2121 • Fax +358 (0)201 212 205
Commissioning