DSC Power832 Installation Manual page 17

K E Y
1. Enter [ ] [5] [Master Code]. The keypad will flash the 'Program' light and turn on the zone light for any
code already programmed.
2. Enter the 2 digit number for the code you want to program. The corresponding zone light will flash.
3. Enter a 4 digit code. The zone light will turn on steady.
4. Continue with steps 2 and 3 until all codes are programmed.
Do not press [ ] or [#] when programming the 4 digit code.
When programming Duress Codes or Partition Master Codes no zone light will flash.
After all the Codes have been programmed press the [#] key to return to the Ready mode.
How to program Access Code Attributes:
"Master Code" attributes cannot change. By default, each code has the attributes of the code
used to program it.
1. Enter [ ][5][Master Code]. The keypad will flash the 'Program' light and turn on the zone light for any
code already programmed.
2. Press [9] to enter the Attribute mode. The keypad will turn on the 'Ready' light and turn off the armed light.
3. Enter the 2 digit number for the code you want to program Attributes for. Zone lights [1] to [4] will be on
or off. Refer to the following chart:
Zone Light 1 - ON - enable code for Partition 1
Zone Light 2 - ON - enable code for Partition 2
Zone Light 3 - ON - enable Zone Bypass
4. Enter [1] to [3] to turn the zone lights ON or OFF, then press [#] key.
5. Continue with steps 2 and 3 until all code attributes are programmed.
After all the codes and attributes have been programmed press the [#] key to exit Access Code
Programming.
How to erase Access Code:
Select the code to be erased and press [ ].
[ ]+[6] User Functions
This keypad command can be used to program several different functions. The following are the items
programmable:
[1] - Time and Date
[2] - Auto-Arm Enable *
[3] - Auto-Arm Time *
[4] - System Test
[5] - Enable DLS (Downloading)
[6] - Enable background music
[7] - For future use
Auto-Arm items (noted with the " " symbol) are programmable by Partition. These must be programmed
at a keypad assigned to the correct Partition (See
To program User Functions:
1. Press [ ] [6] [Master Code]. The keypad will flash the 'Program' light.
2. Press the number [1] to [5] for the item to be programmed.
• [1] - Time and Date
The time and date must be accurate for the Auto-Arm or Test Transmission functions to work properly. In
addition the event buffer time and date stamps all events.
- Enter the time: hour and minute, using military format [HH MM]. (00:00 to 23:59)
- Enter the date: month, day and year [MM DD YY].
All entries must be 2 digits. January, for example, would be month [01].
• [2] - Auto-Arm Enable/Disable (Shall not be enabled on UL Listed systems)
Auto-Arming will not work until it is enabled for the Partition.
Press [2]. If the keypad beeps 3 times rapidly Auto-Arm is enabled, one long beep means it is disabled.
• [3] - Auto-Arm Time
Each Partition can be programmed to Auto-Arm at a different time.
Enter the time, hour and minute, using military format [HH MM].
All entries must be 2 digits. Eight o'clock in the morning would be [08] hours and [00] minutes.
P A D C O M M
Section 2.6 "Keypad Assignment").
17
A N D S