Brother PR655 Service Manual page 39

Main unit
2
Feed final assembly removal
1. Draw the feed final assembly toward you.
2. Unlock the connector of the Y-area sensor assembly, and then remove the
FFC SML2CD-Y 1 from the Y-area sensor assembly.
3. Remove the screw 1, and then remove the FFC SML2CD-Y and Y cable
protection sheet A.
4. Remove the 4 screws 2, and then remove the 2 fixed Y-shaft plates (one
each on left and right).
5. Remove the feed final assembly and the 2 Y-guide shafts 2.
Feed unit
2 - 18
1
1
1
2
2 2