Presser Foot Height - Brother PR655 Service Manual

Adjustment
[Standard]
The clearance between the section surrounding the needle plate hole and the bottom face of the presser foot should be
0.8 to 1.4 mm.
[Adjustment]
1. Attach the needle plate and turn the pulley by hand to move the needle bar to its lowest position.
2. Loosen the screw 1 of the needle bar clamp.
3. Adjust the presser foot height.
4. Tighten the screw 1 of the needle bar clamp to secure the presser foot.
5. Repeat the same steps to adjust the presser foot height for the other needle bars.
1
1
Presser foot
Presser foot
Needle plate

Presser foot height

Screw Flat
M4
Presser foot
4 - 25
Needle bar clamp
Needle plate hole
Presser foot height
0.8 - 1.4 mm
Top face of
needle plate
Needle plate
Section surrounding