Sub Tension Assy - Brother PR655 Service Manual

Hide thumbs Also See for PR655:
Table of Contents

Advertisement

Replacement
To replace the "thread guide tension screw" to the upper thread adjustable "sub tension assy" on the machine with
"thread guide tension screw", follow the instructions below.
1. Remove the tension base from the machine.
2. Remove the cap from the thread guide tension screw.
3. Remove the thread guide tension screw from the tension
base.
*Key point
• When the thread guide tension screw is removed
from the tension base, Nut 2 M3 in the tension base
comes off. Be sure to keep it for later use.
4. If the upper thread eyelet base and thread guide tension
plate are detached, set them on the tension base again.
5. Attach the thread guide compression to the sub tension
assy.
6. Secure the nut (Nut 2 M3) into the hole of the tension base
to attach the sub tension assy to the tension base.
7. Attach the cap to the sub tension assy.
8. Turn all sub tension assy tabs anti-clockwise so that they
are at the highest position to provide the least load onto
the upper thread.
9. Sew trial stitches to check if it works properly.
*Key point
• If it does not sew properly, fine-tune the upper thread
tension by turning the tab.

Sub tension assy

6 - 24
Cap
Thread guide
tension screw
Thread guide
tension plate
Cap
Sub tension assy
Thread guide
compression
Thread guide
tension plate
Upper thread
eyelet base
Tension base
Nut 2 M3
Upper thread
eyelet base
Tension base
Nut 2 M3
Tab

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pr655c

Table of Contents