Frame Rate - Panasonic WV-SFV781L Operating Instructions Manual

•
On: H.264 images and audio will be transmitted using the HTTP port. Refer to page 127 for further
information about the HTTP port number settings.
•
Off: H.264 images and audio will be transmitted using the UDP port.
•
Default: Off
Note
•
When "On" is selected, only "Unicast port (AUTO)" will be available for "Transmission type".
•
When "On" is selected, it may take time to start displaying H.264 images.
•
When "On" is selected, H.264 images may not be displayed depending on the number of the concurrent
access user and audio data availability, etc.
•
When "On" is selected, only IPv4 access is available.
[Image capture size]
Select the image capture size. The image capture sizes that can be selected depend on "Image capture
mode". For information on the image capture sizes that can be selected, refer to page 10.
•
Default:
–
H.264(1): 3840x2160
–
H.264(2): 640x360
[Transmission priority]
Select a transmission priority for H.264 images from the following.
•
Constant bit rate: H.264 images will be transmitted with the bit rate selected for "Max bit rate (per
client) *".
•
VBR: H.264 images will be transmitted with the frame rate selected for "Frame rate*" while maintaining the
image quality level selected in "Image quality". H.264 images will be transmitted with the bit rate kept within
the maximum bit rate that is set for "Max bit rate (per client)*". The image quality is fixed, and the recording
capacity changes according to the "Image quality" setting and conditions of the subject. When calculation
of recording capacity is needed in advance, use "Advanced VBR".
•
Frame rate: H.264 images will be transmitted with the frame rate selected for "Frame rate*".
•
Best effort: In accordance with the network bandwidth, H.264 images will be transmitted with the bit rate
varying between the maximum and minimum bit rates that are set for "Max bit rate (per client)*".
•
Advanced VBR: H.264 images are transmitted at the frame rate specified for "Frame rate*" while the image
quality is controlled so that the average transmission rate during the period specified for "Control time
period" becomes the bit rate selected for "Max bit rate (per client)*".
•
Default: Frame rate
Note
•
When "Frame rate" or "Advanced VBR" is selected for "Transmission priority", number of users who
can access the camera may be limited more (may become less than 10).

[Frame rate*]

Select a frame rate for H.264 images from the following. The frame rate that can be selected depend on "Image
capture mode". For information on the frame rates that can be selected, refer to page 10.
1fps/ 3fps/ 5fps*/ 7.5fps*/ 10fps*/ 12fps*/ 15fps*/ 20fps*/ 30fps*
•
Default: 30fps*
Note
•
When "Frame rate", "Advanced VBR", or "VBR" is selected for "Transmission priority", this setting is
available.
•
"Frame rate*" is restricted by "Max bit rate (per client)*". For this reason, the frame rate may be lower
than the specified value when any value marked with an asterisk (*) is selected. When "VBR" is selected
for "Transmission priority", depending on the settings of "Max bit rate (per client)*" and "Image
11 Configure the settings relating to images and audio [Image/Audio]
Operating Instructions 73