Panasonic WV-SFV781L Operating Instructions Manual page 53

Note
•
If the "Upside-down" setting is changed when the following area settings are configured, the positions
of areas may move out of alignment. Therefore we recommend that you configure the area settings
after configuring the "Upside-down" setting.
–
Mask area (page 86)
–
Privacy zone (page 94)
–
VMD area (page 114)
–
VIQS area (page 96)
–
Preset position (page 92)
[Indicator]
Determine whether or not to use the following indicators. Select "On" to use the following indicators to check
the operational status by lighting them. Select "Off" to turn off the indicators at all times.
–
Link indicator (LINK)
–
Access indicator (ACT)
–
SD memory card error indicator/AF indicator (SD ERROR/AF)
–
SD MOUNT indicator (SD MOUNT)
•
Default: On
Note
•
Link indicator (LINK) (orange): This indicator will light when communication with the connected
device is available.
•
Access indicator (ACT) (green): This indicator will blink when accessing a network.
•
SD memory card error indicator/AF indicator (SD ERROR/AF) (red): Lights when an error occurred
in the SD memory card. This LED will blink in the process of the auto focus function and blinking will
stop when the focus adjustment is complete. Except when the auto focus is being used, when the
indicator lights, it indicates that an error occurred in the SD memory card.
•
SD MOUNT indicator (SD MOUNT) (green): Lights when data can be saved to the SD memory card.
It blinks or is off when data cannot be saved to the SD memory card.
–
Indicator is off: Indicates "Not use" is selected for SD memory card, or an error occurred for the
SD memory card.
–
Indicator blinks: Indicates the SD memory card is being recognized or is performing the necessary
processing for the SD memory card to be removed.
–
Indicator lights: Indicates data can be saved to the SD memory card.
[Alarm status update mode]
Select an interval of the camera status notification from the following.
When the status of the camera changes, the alarm occurrence indication button, the [AUX] button or the SD
saving status indicator will be displayed to notify of the camera status.
•
Polling(30s): Updates the status each 30 seconds and provide notification of the camera status.
•
Real time: Provide notification of the camera status when the status has changed.
•
Default: Real time
Note
•
Depending on the network environment, notification may not be provided in real time.
•
When multiple cameras are using the same "Alarm status reception port", even if "Real time" is selected
for "Alarm status update mode", status notification is not provided in real time. In this case, change the
"Alarm status reception port" settings.
[Alarm status reception port]
When selecting "Real time" for "Alarm status update mode", designate a port number to which the status change
notification is to be sent.
10 Configure the basic settings of the camera [Basic]
Operating Instructions 53