Panasonic WV-SFV781L Operating Instructions Manual page 100

11 Configure the settings relating to images and audio [Image/Audio]
4.
Click the [Set] button.
→
This unit is updated with the setting contents. Click the [Delete] button corresponding to the area to be
deleted.
5.
Click the [Confirm] button.
→
The image ("H.264(1)", "H.264(2)", "H.264(3)", or "H.264(4)") that the [Confirm] button was pressed for
is displayed. When a window is newly opened and about 3 seconds pass, the currently outputted bit
rate can be confirmed with the configured VIQS.
IMPORTANT
•
No setting contents are determined unless the [Set] button is clicked.
•
To check the image after configuring VIQS, display an H.264 image on the "Live" page, or press the
[Confirm] button under "Stream".
•
The outputted bit rate changes depending on the subject. Confirm the bit rates with actual subjects
used when operating the camera.
100 Operating Instructions