Setting Playback Timer - JVC UX-DM9DB Instructions Manual

Setting Playback Timer

You can use Playback Timer for all sources.
• You can store three timer settings in total for Recording
Timer (see page 40) and Playback Timer.
• To exit from the timer setting, press CLOCK/TIMER as
required.
• To correct a mis-entry during the process, press CANCEL.
You can go back to the previous step.
How Playback Timer works
Once the Playback Timer has been set, the
and timer number (1, 2, or 3) indicator are lit on the
display. Playback Timer is activated at the same time
everyday until the timer is turned off manually.
• Playback Timer starts working only when the System is
turned off (on standby).
When the start time comes
The System turns on, starts playing the specified source,
and increases the volume level gradually to the preset
level for about 30 seconds.
When the end time comes
The System stops playback and turns off (standby).
• The timer setting is stored until you change it.
1 Prepare the playback source.
• When you want to listen to the radio broadcast:
Preset the desired station or service. (See page 8 for
FM/AM or page 19 for DAB.)
• When you want to play back the disc:
Insert a disc. (See "To insert a disc" on page 9.)
• When you want to play back the USB device:
Connect the USB device (see page 9).
• When you want to play back an iPod:
Before connecting the iPod, switch the charge mode to
"ON."
Connect an iPod and pause playback at the beginning of
the desired track (see page 11).
• When you want to play back the external equipment:
Connect the external equipment to the AUX jack (see
page 12) and set the timer on the equipment.
2 Make the timer setting, following steps 2 to 7 of
"Setting Recording Timer" on page 40 and 41.
3 Select "PLAY TIMER."
Remote
INFO
ONLY
indicator
4 Select the source to play.
• When you want to listen to the radio broadcast:
Select the preset number of the desired station or
service.
• You can also use the number buttons to select the
preset number.
• When you want to play back a disc, built-in memory
or USB device:
Select the group number, then the track number of the
desired track.
• When the loaded disc is an audio CD, simply select the
track number, then press SET.
5 Adjust the playback volume.
• You can also use the number buttons to adjust the
playback volume.
6 Turn off the System.
To cancel Playback Timer
In step 2 on page 40, select the timer number you want to
cancel, then press CANCEL.
• Even when you cancel Playback Timer, the setting remains
stored.
To activate Playback Timer again
In step 2 on page 40, select the timer number you want to
activate, then press ENTER. The settings appear on the
display. After you confirm it, turn off the unit.
42