Setting The Timer - JVC UX-A3 Manual

UX-A3 B/E/G/GI/EN |
Notes:
Once the timer has been set, the start and stop times,
etc., are stored in memory. When timer recording or
playback is required at different times, the timer must be
set again.
e After setting the timer start and stop times, check that
the unit is tuned to the required frequency.
@ When the power cord is disconnected or there is a power
failure, timer settings will be erased from memory. If this
happens, set the current time and perform the timer
setting again.
Setting the timer
@ The current time must be set before the timer can be
used.
@ Press the TIMER button.
@ Set the start time.
(Example: when the timer start time is set to 12:15)
@ Adjust the hours.
CO/TUNING/TIMER
ea Pi
'
Blinks
> af
eS
we
DOWN UP
Y
@® Adjust the minutes.
Within the 30 sec.
COTUNINGIT IMER
mpl
Blinks ane Blink
DOWN
UP ON
'
-»
' OFF f,
ie ca
tee dao
© Press to set the start time.
Within 30 sec.
@ Set the stop time
(Example: when the timer stop time is set to 13:15.)
@ Adjust the hours.
CD/TUNING/TIMER
<a >>|
DOWN UP Blinks
OFF \
a
_!
ee
20 (No. 1850)