Presetting Services - JVC UX-DM9DB Instructions Manual

To scan for ensembles
The System scans the DAB bands to pick out available
ensembles under your receiving conditions.
• When you change the source to DAB for the first time after
plugging in the power cord, the System automatically
performs the scanning.
To start the scanning
When you move your System or adjust the antenna position,
perform the scanning manually.
2 sec.
When the scanning is complete, the System selects the first
service of the ensemble found first.
To tune in to all the ensembles
You can tune in to every ensemble regardless of the signal
status.
ENSEMBLE SEARCH
The frequency changes every second through all of the
ensembles regardless of their signal status.
• Release the button when the desired ensemble is reached.
To improve DAB reception
With the supplied DAB antenna, you may not be able to
receive L-Band ensembles.You can improve the reception of
both L-Band and Band III ensembles by using an active
antenna (see page 4).
While on standby...
2 sec.
ANTENNA OFF
• You cannot change this setting when the display is turned
off (see page 14).
19
Remote
ONLY
12B 12C 12D
Remote
ONLY
ANTENNA ON
(Canceled)

Presetting Services

You can preset 30 services.
1 Tune in to an ensemble, then select a service you want
to preset.
2 Activate the preset number entry mode.
3 Select a preset number for the service you store.
Examples:
To select preset number 5, press
5.
To select preset number 10, press
10.
To select preset number 15, press
To select preset number 30, press
4 Store the service.
• You can only preset primary services. If you select a
secondary service to store, its primary service is stored
instead.
To tune in to a preset service
1 Select DAB.
DAB
AUX
2
Select the preset number for the service you have
stored.
Examples:
To select preset number 5, press
5.
To select preset number 10, press
10.
To select preset number 15, press
To select preset number 30, press
Remote
INFO
ONLY
10, 1, then 5.
10, 3, then 0.
Remote
ONLY
FM
AM
10, 1, then 5.
10, 3, then 0.