Changing The Display Mode - JVC UX-DM9DB Instructions Manual

Changing the Display Mode

While listening to a DAB service...
1
Clock
*
USB REMAIN
"NO SIGNAL" will appear if no signal is
Service
sent.
label
The broadcast program type is displayed.
PTY
"NO PTY" will appear if no signal is sent.
Dynamic Label Segment (text messages
DLS
the station sends) is displayed. "NO
TEXT" will appear if no signal is sent.
1
* Non DAB signal.
2
* See page 15.
Searching for a Service by PTY Codes
You can locate a particular kind of program from among all
the services you can receive by specifying a PTY code.
• For details about PTY codes, see page 17.
1
While listening to an DAB service...
2 Select a PTY code.
3
Start searching.
Ex. When "News" is selected
Remote
INFO
ONLY
Service label
PTY
DLS
Ensemble ID
Frequency
2
*
MEM REMAIN
Remote
ONLY
The System searches all the available ensembles, and
switches to a program of the selected PTY code when
found.
• If no program is found, "NOT FOUND" appears on the
display.
• To stop searching, press PTY SEARCH or CANCEL.
To continue searching after it stops on an unwanted
service
Press PTY SEARCH again.
Switching Temporarily to a Service of
2
*
Your Choice Automatically
PTY Standby Reception function allows the System to
temporarily switch to a DAB service broadcasting a program
of your choice (TA, News, or Info).
• This function works while listening to a service providing
the required signals.
While listening to a DAB service, select the program
type.
Traffic announcement in your area.
TA
News.
News
Program the purpose of which is to impart
Info
advice in the widest sense.
Remote
ONLY
TA News
Info
OFF
(Canceled)
20