Setting The Once Rec (Recording) Timer - JVC CA-D5T Instructions Manual

Setting the ONCE REC (Recording) Timer
Z|e
3
cLocK
{ tyeR J
CAUTION: If the CA-D5T is unplugged, or a power failure occurs, the timer setting will be erased
after 2 or 3 days. If the settings are erased in this way, reset the timer settings.
With the Recording Timer you can make a tape of a radio broadcast automatically whether or not
you are home. For the timer to work correctly, you need to make sure of the following in addition to
setting the time for the Tuner and Cassette Deck to come on:
OQ You can set the Recording Timer whether the Unit is on or off.
Q) The tape you want to record onto must be in Deck B.
The radio station whose program you want to tape must be the last one played before the timer
comes on.
Procedure for Setting the Recording Time
7. Press the TIMER button until "ONCE REC" appears in the display.
The message "ONCE REC" blinks on the display and the ONCE REC indicator light blinks.
© iiQNCl' Pll ==
B&B. cossan TE! ite 7
)
) The display changes with each press of the button, as shown below.
DAILY (blinks) -> ON TIME (blinks) > ONCE REC (blinks) > ON TIME (blinks) > CLOCK
(blinks) (Clock setting mode) ~ original display before the TIMER button was pressed >
to the beginning)
Z. Press the TIMER button again.
The display changes from "ONCE REC" to the setting display for the Timer ON time.
3. Set the time you want the radio to come on, and put a tape in Deck B to record on.
QO Use the kd or 1 button to set the start time, then press the SET button.
4. Set the time you want the radio to shut off and the tape in Deck B to stop recording.
1 Use the << or > button to set the off time, then press the SET button.
The message "TIMER OK" is displayed, and the blinking "ONCE REC" indicator changes
to a continuously lit display to let you know that the ONCE REC Timer setting is complete.
5. Turn the power off.
When the set time comes, the CA-DST turns the power on and records the broadcasting station
you selected last, before turning the power off.
Q Ifa button is pressed when the Recording timer is operating, recording continues but the
timer is canceled.
Before the Timer Starts
Q Check that the recording direction for the tape and the TAPE indicator are the same.
Set Reverse Mode to on if you want to record on both sides of the tape. Check that the recording
direction and the direction of the TAPE indicator are correct. (See "Notes for using Reverse
Mode for recording" on page 25.)
2 The VOLUME control is automatically set to 0 when ONCE REC Timer is recording.
it is very easy, and can be very disappointing, to forget to put in a tape, or to accidentally leave a
tape in Deck B you don't want recorded over. Although this happens to almost everyone at one time
or another, we hope it won't happen to you!
To Change the Recording Timer Setting
To change the settings for the ONCE REC Timer, repeat the setting procedure from the beginning.
31