Glowforge Manual page 33

5. Place Printer Head and Power Cord in Foam Block
a. Remove all the packaging pieces stored in the white rear foam block. Gently lay
the printer head and power cord into the foam as pictured.
Remove the Crumb Tray and Exhaust
Remove the crumb tray and exhaust vent following the instructions below. The crumb tray,
exhaust hose, and lens tool are packed in the Accessories Box.
1. Lower the Front Door and Remove the Crumb Tray
a. Lift the lid, then lower the front door. Lift the crumb tray slightly and slide it
towards you. Be careful not to tilt the crumb tray up, or it will knock into the laser
arm and rails.
2. Empty Your Crumb Tray
a. Lower the front lip of the crumb tray and dump the contents of the crumb tray
catch area. Afterwards, you may invert the crumb tray to remove anything that
may be left.
3. Wipe the Floor of Your Glowforge
a. Wipe the metal floor of the Glowforge unit with a soft cloth to sweep away any
bits.
Copyright Glowforge, Inc. 2017
DRAFT