Glowforge Manual page 32

2. Remove the Printer Head
a. Holding only the finished black surfaces,
grasp the printer head as shown. Pull gently
up and back to disengage the magnets and
remove the head.
3. Unplug the Wire Ribbon
a. Push down fully on the wire ribbon tab to
unplug the wire ribbon from the printer
head. Pull the wire ribbon gently away
and tuck it into the laser arm.
4. Insert the Orange Foam
a. Being careful to only touch the finished black
surfaces, insert the orange foam into the head
Copyright Glowforge, Inc. 2017
DRAFT