Glowforge Manual page 18

3. Remove Knobs
a. To the left and right, you'll find red
knobs. Unscrew and pull them out.
4. Reveal Printer Head and Power Cord
a. Remove the top layer of the rear
foam block to reveal your Printer
Head and power cord
5. Remove Rear Foam Block
a. Gently remove the rear foam block, including the Printer Head and power cord.
Set these aside for now.
6. Remove Clip
a. Under the glass tube, you'll find an
orange clip. Push down on it and it will
pop off.
Copyright Glowforge, Inc. 2017
DRAFT