D-Link DES-7200 Cli Reference Manual page 73

DES-7200 CLI Reference Guide
Commands
Platform
description
5.1.4
Use this command to show all gateways passed by the test packets from the
source address to the destination address.
traceroute [ ipv6 ] [ ip-address [ probe number ] [ timeout seconds ] [ ttl
minimum maximum ] ]
Parameter
description
Command
mode
Usage
guidelines
Examples
Chapter 5 Network Connectivity Test Tool Configuration
12 219.142.11.10
13 211.157.37.14
14 222.35.65.1
15 222.35.65.18
16 222.35.15.109
17 *
18 64.170.98.32
The command is supported by all equipments.
traceroute
ipv6
Parameter
Ipv6-address
number
seconds
minimum
maximum
Privileged mode.
Use the traceroute ipv6 command to test the connectivity
of a network to exactly locate the network connectivity
problem when the network failure occurs. To use the
function domain name, configure the domain name server.
For the concrete configuration, refer to the DNS
Configuration part.
The following is two examples of the application bout
traceroute ipv6, the one is of the smooth network, and the
other is the network in which some gateways aren't
connected successfully.
1. When the network is connected smoothly:
.
40 msec 50 msec 30 msec
50 msec 40 msec 50 msec
40 msec 50 msec 40 msec
40 msec 40 msec 40 msec
50 msec 50 msec 50 msec
* *
40 msec 40 msec 40 msec
Description
Specifies an IPv6 address.
Specifies the number of probe packets
to be sent.
Specifies the timeout time.
Specifies the minimum and maximum
TTL values.
5-7