D-Link DES-7200 Cli Reference Manual page 67

DES-7200 CLI Reference Guide
Commands
5
5.1 Configuration Related
Commands
5.1.1
Use this command to test the connectivity of a network to locate the network
connectivity problem. The command format is as follows:
ping [vrf vrf-name | ip] [ip-address [length length ] [ntimes times] [timeout
seconds] [data data] [source source] [df-bit] [validate]]
Parameter
description
Default
Chapter 5 Network Connectivity Test Tool Configuration
Network Connectivity Test Tool
Configuration Commands
ping
Parameter
vrf-name
ip-address
length
times
seconds
data
seconds
df-bit
validate
Five packets with 100Byte in length are sent to the
specified IP address within specified time (2s by default).
.
Description
VRF name
Specifies an IPv4 address.
Specifies the length of the packet to be
sent.
Specifies the number of packets to be
sent.
Specifies the timeout time.
Specifies the data to fill in.
Specifies the source IPv4 address or
the source interface. The loopback
interface address(for
127.0.0.1) is not allowed to be the
source address.
Sets the DF bit for the IP address. DF
bit=1 indicates not to segmentate the
datagrams. By default, the DF bit is 0.
Sets whether to validate the reply
packets or not.
example:
5-1