D-Link DES-7200 Cli Reference Manual page 31

DES-7200 CLI Reference Guide
Usage
guidelines
Examples
Related
commands
Chapter 2 Switch Management Configuration Commands
This command is used to specify the device's boot
configuration filename. When booting the device, the system
loads configuration file according to the following principles:

If the service config command is not configured, the
sequence of loading configuration files is as follows:
boot configuration filenames configured using the boot
config command,
configuration filenames configured using the boot
network command, and the default factory-delivered
configuration (null configuration).

If the service config command is configured, the
sequence of loading the configuration file is as follows:
network boot configuration filename configured using
the boot network command, boot configuration filename
configured using
flash:/config.text, and the default factory-delivered
configuration (null configuration).

When loading the files in sequence, the system will not
load the other configuration files as long as one
configuration file is successfully loaded.
This function can be used for fast failure recovery when the
device's main configuration file is damaged.
As this command configuration is used by
the system in the early boot stage, the
configuration is saved in the device Boot
Caution
ROM instead of the configuration file.
The following example sets the device's boot configuration
filename as "flash:/config_main.text":
DES-7200(config)# boot config flash:/config_main.text
Command Description
Set
boot network
configuration filename.
Allow the device to first download the
service config boot configuration file from a remote
network server.
Show the device's boot configuration.
show boot
.
flash:/config.text, network
the boot config
the device's network
boot
command,
boot
2-21