D-Link DES-7200 Cli Reference Manual page 71

DES-7200 CLI Reference Guide
Commands
traceroute [vrf vrf-name | ip] [ip-address [probe number ] [source source]
[timeout seconds] [ttl minimum maximum]]
Parameter
description
Command
mode
Usage
guidelines
Examples
Chapter 5 Network Connectivity Test Tool Configuration
Parameter Description
vrf-name VRF name
ip-address Specifies an IPv4 address.
Specifies the number of probe packets
number
to be sent.
Specifies the source IPv4 address or
the source interface. The loopback
source interface
127.0.0.1) is not allowed to be the
source address.
seconds Specifies the timeout time.
minimum Specifies the minimum and maximum
maximum TTL values.
Privileged mode.
Use the traceroute command to test the connectivity of a
network to exactly locate the network connectivity problem
when the network failure occurs. To use the function
domain name, configure the domain name server. For the
concrete configuration, refer to the DNS Configuration
part.
The following is two examples of the application bout
traceroute, the one is of the smooth network, and the other
is the network in which some gateways aren't connected
successfully.
1. When the network is connected smoothly:
DES-7200# traceroute 61.154.22.36
< press Ctrl+C to break >
Tracing the route to 61.154.22.36
1 192.168.12.1
2 192.168.9.2
3 192.168.9.1
4 192.168.0.10
5 192.168.9.2
6 202.101.143.154
7 61.154.22.36
.
address(for example:
0 msec 0 msec 0 msec
4 msec 4 msec 4 msec
8 msec 8 msec 4 msec
4 msec 28 msec 12 msec
4 msec 4 msec 4 msec
12 msec 8 msec 24 msec
12 msec 8 msec 22 msec
5-5