D-Link DES-7200 Cli Reference Manual page 35

DES-7200 CLI Reference Guide
2.2.6
This command is used to set a filename for the device's startup main program
and specify the boot priority. The no form of this command is used to delete the
filename of the main program corresponding to the priority.
boot system priority prefix:/[directory/]filename
no boot system [priority]
Parameter
description
Default
configuration
Command
mode
Chapter 2 Switch Management Configuration Commands
show boot
boot config
boot ip
service config
boot system
Parameter
priority
prefix:
/[directory/]filename
The default filename of the main boot program is flash:/
firmware.bin, with the priority being 5.
Global configuration mode.
.
Show the boot related configuration of
the device.
Set the device's boot configuration
filename.
Configure the local IP for TFTP
transmission during device booting.
Allow the device to first download the
boot configuration file from a remote
network server.
Description
Boot priority of a main program, in
the range of 1 to 10, and 1 is for the
highest priority.
Prefix of the file system. Note that
prefix can be used to locate and
access files in V10.4(2) or later
versions. Refer to File System
Configuration Guide for details.
Filename of a main program used
for booting. Note that when the
prefix is used to locate a file, the
directory following ":" should be the
absolute path.
2-25