D-Link DES-7200 Cli Reference Manual page 62

DES-7200 CLI Reference Guide
4
4.1 Configuration Related
Commands
4.1.1
Set the applied ACL (Access Control List) in Line. Use the access-class
{ access-list-number | access-list-name }
the ACL in Line. Use the no access-class
access-list-name} {in | out} command to cancel the ACL configuration in LINE.
access-class { access-list-number | access-list-name } {in | out}
no access-class { access-list-number | access-list-name } {in | out}
Parameter
description
Default
configuration
Command
mode
Usage
guidelines
Chapter 4 LINE Configuration Commands
LINE
Commands
access-class
Parameter
access-list-number|
access-list-name
in
out
By default, no ACL is configured under Line. All
connections are accepted, and all outgoing connections
are allowed.
Line configuration mode.
This command is used to configure ACLs under Line. By
default, all the incoming and outgoing connections are
allowed, and no connection is filtered. After access-class
is configured, only the connections that pass access list
.
Configuration
{ in | out } command to configure
{access-list-number |
Description
Specify the ACL
access-list
Perform access control over the
incoming connections
Perform access control over the
outgoing connections
defined by
4-1