D-Link DES-7200 Cli Reference Manual page 34

DES-7200 CLI Reference Guide
Usage
guidelines
Examples
Related
Chapter 2 Switch Management Configuration Commands
This command is used to specify the device's network boot
configuration filename. When booting the device, the system
loads the configuration file according to the following
principles:

If the service config command is not configured, the
sequence of loading the configuration file is as follows:
boot configuration filename configured using the boot
config command,
configuration filename configured using the boot
network command, and the default factory-delivered
configuration (null configuration).

If the service config command is configured, the
sequence of loading the configuration file is as follows:
network boot configuration filename configured using
the boot network command, boot configuration filename
configured using
flash:/config.text, and the default factory-delivered
configuration (null configuration).

When loading the files in sequence, the system will not
load the other configuration files as long as one
configuration file is successfully loaded.
This function can be used for fast failure recovery when the
device's master configuration file is damaged accidentally.
You should use the boot ip command to
correctly configure the local IP address
used by the device during booting, before
the system can get the remote file through
TFTP. Otherwise any TFTP transmission
will fail during booting.
Caution
As this command configuration is used by
the system in the early boot stage, the
configuration is saved in the device Boot
ROM instead of the configuration file.
The following example configures the network boot
configuration filename for the device:
DES-7200(config)#
tftp://192.168.7.24/config.text
Command Description
.
flash:/config.text, network
the boot config
boot
boot
command,
network
2-24