Accessing The Brew Unit Drive - Miele CVA 610 Technical Information

Technical Information
Figure 5-34: Ram Assembly
5.38

Accessing the Brew Unit Drive

5.38.1 CVA 610
1. Disconnect the power. Allow the appliance to cool.
2. Remove the brew unit from the appliance; see Section 5.26.
3. Remove the waste container from the appliance.
4. Remove the beans container and beans container guide; see Sections 5.42 and
5.43.
5. Remove the lid; see Section 5.1.
6. Remove the interference suppression capacitor; see Section 5.2.
7. Remove the rear panel; see Section 5.6.
8. Disconnect the door ribbon cable (JP16) from the CPU electronic.
9. Lift the steam heater/mounting bracket assembly out of the appliance and hang it
on the outside of the appliance.
10. Move wires and hoses out of the way of the brew unit drive and tie them down as
necessary.
11. Remove the 7 Phillips screws securing the brew unit drive cover to the brew unit
drive assembly. See Figure 5-35.
12. Refer to Section 4.15 for information on the drive assembly.
CVA 610/CVA 615 Coffee Systems
1 Filter screw
2 Filter
3 Lubrication points
62