Grinder Assembly And Basic Setting - Miele CVA 610 Technical Information

CVA 610/CVA 615 Coffee Systems
5.45

Grinder Assembly and Basic Setting

Note:
The grinder ring (Figure 5-49, Item 6) and the grinder cone (Figure 5-49,
Item 5) should only be replaced together.
1. Replace the felt ring (Figure 5-49, Item 11).
2. Replace the carriers (Figure 5-49, Item 10).
3. Replace the mounting (Figure 5-49, Item 7).
4. Replace the springs (Figure 5-49, Item 9).
5. Replace the balls (Figure 5-49, Item 8).
6. Replace the grinding cone (Figure 5-49, Item 6); ensure that the balls are seated
in the grinding cone.
7. Replace the washer (Figure 5-49, Item 3).
8. Replace the intake worm gear (Figure 5-49, Item 2), press it down, and turn it
until the coupling engages.
9. Tighten the grinding cone retaining screw (Figure 5-49, Item 1) counterclockwise
(left-hand thread!). Ensure that the intake worm gear coupling has engaged
properly.
Note:
Remove all coffee from the grinder before setting it.
10. Replace the bracket (Figure 5-48, Item 3).
11. The blue marking on the carrier (Figure 5-48, Item 2), has the same position as
the blue marking on the adjustment ring (Figure 5-48, Item 1); both point toward
the front of the appliance.
12. Turn the adjustment ring clockwise as far as possible.
13. Turn the adjustment ring counterclockwise by 6 settings so that the adjustment
lever can be secured at a middle setting.
14. Replace the adjustment lever so that the grinder is set to a medium grinding
grade.
15. Tighten the adjustment lever retaining screws.
16. Push on the handle.
17. Check to see that the grinder is functioning properly. If not, repeat Steps 13 to 16
(turning the adjustment ring by 2 or 3 settings at a time) until the grinder is
properly adjusted. Typical setting range for the adjustment ring is between 6 and
16 settings.
Note:
It may take up to three servings of coffee to determine whether or not an
adjustment is correct.
5.46 Grinder Removal
1. Open the door.
2. Remove the beans container; see Section 5.42.
3. Remove the waste container, brew unit and water tank.
4. Remove the lid; see Section 5.1.
5. Remove the beans container guide. See Section 5.43.
Technical Information
73