Brew Unit Lubrication - Miele CVA 610 Technical Information

CVA 610/CVA 615 Coffee Systems
5.32

Brew Unit Lubrication

1. Remove the brew unit; see Section 5.26.
Note:
Check that the brew unit is in the basic position with the funnel slightly lifted and the
socket in the vertical position.
2. Refer to Figure 5-25 below; lubricate the following:
Figure 5-25: Brew Unit Lubrication Points (1)
3. Refer to Figure 5-26 below; lubricate the following:
Figure 5-26: Brew Unit Lubrication Points (2)
4. Re-install the brew unit into the appliance.
5.33 Brew Unit Manual Reset to "Home" Position (Brew Unit Not
Installed in Appliance)
1. Press on the latch (Figure 5-27, Item 1) and press the funnel down (Figure 5-27,
Item 2).
2. Push the connection piece to the far left position (Figure 5-27, Item 3).
3. Press "PRESS" once.
Technical Information
1 Joints
2 Axle
3 Tracks
4 Gasket
1 Bolt assembly
2 Joints
57