Table of Contents
Advertisement
9
Microphone Operation
This function can be temporarily used in channel mode. Once the
radio is turned off or switched to another channel, the temporary
setting will be erased and back to initial settings.
Scan Skip
In Channel mode, press
It means current channel is scan skip. Repeat above operation to set
scan or scan skip in current channel. Decimal point dissapears when the
channel is available for scanning.
Frequency/Channel scan
In corresponding mode,press
scanning.
In scanning mode,press
Press [PTT] to stop scanning.
25
Busy Channel Lockout
BCLO is to disable transmitting while RX signal is received. Once the
channel is busy and you press PTT, the radio will beep as warning and
get back to receiving.
1.
In standby,press
Lockout.
2.
Press [
/
BU: Enable BCLO, Carrier lockout, transmitting is inhibited when
current channel receives a matching carrier;press [PTT] to emit error
voice prompt.
RL: Enable BTLO, transmitting is inhibited when current channel
receives a matching carrier but dis-matching CTCSS/DCS.press
[PTT] to emit error voice prompt It can transmit in any receiving
status.
then press
,decimal point appears.
then press
/
to change scan direction.
,then press
to enter into Busy Channel
] to select the desired value.
OFF: Busy channel lockout is disabled.
3.
Press number keys to confirm and exit.
Reverse TX/RX
TX frequency turns to RX frequency & RX
frequency changes to TX frequency. The
signaling will also be reversed if CTCSS/DCS
signaling exited in this channel.
1.
In standby,press
2.
Press [
ON:Enable Frequency Reverse
key to start
OFF:Disable Frequency Reverse
3.
Press number keys to confirm and exit.
TOT (Time-out timer)
The time-out timer limits the amount of transmitting time. When you
reach the time limit which has been programmed by your dealer, your
transmission will be cut off. In order to transmit again, you must release
PTT button to reset the timer.
1.
In standby,press
2.
Press [
3.
Press number key to confirm and exit.
CTCSS/DCS Encode and Decode
1.
In standby,press
Encode and Decode.
2.
Repeat above operation to set as below:
,then press
, LCD displays "REV—OF".
/
] to select the desired value.
,then press
"LCD displays "TOT-X".
/
] to select the desired value.
, then press
to enter into CTCSS/DCS
Advertisement
Table of Contents
