Frequency/Channel Scan; Channel Scan Skip - Alinco DJ-CRX7 Instruction Manual

BASIC OPERATIONS

Frequency/Channel Scan

Under corresponding mode, press
start frequency scan or channel scan.
1. Frequency Scan
Under VFO mode, this function is used for monitoring signal of various communication
frequency by transceiver 'step' setup, (see the setting in menu 6). During scanning, press
key to adjust scanning speed, transceiver will switch MHz step or KHz step. press
numeric key or key to exit.
2. Channel Scan
Under channel mode, transceiver will scan all the stored channels. Press numeric key
or key to exit.
NOTE:
▼
Frequency scan is of all bands scan, it scans upwards as your STEPPING setting.
▼ In channel scan, the skipped channel is not in the line of scanning. Scan upwards as per channel no.
(please refer to channel scan skip).
▼ Frequency/channel scan can change scan direction by press
signaling, the transceiver will stay 5 seconds then go on scanning. (Please refer to scan setup)

Channel Scan Skip

Under channel mode, press
current channel as Channel scan skip. Repeat above operation to cancel channel scan skip.
1. LCD displayed " " means the current channel will not be scanned.
2. " " icon disappeared means the current channel will be scanned.
key, the top corner of LCD displays "
key, the top corner of LCD displays "
" icon, then press
/
, when find a matching carrier wave and
" icon, then press
key to
key to set the
18