Furuno FS-5075 Operator's Manual page 49

Routine priority
a) Rotate the ENTER knob to select CHANNEL or FREQUENCY and then press the
ENTER knob.
b) Enter TX/RX frequency or channel referring to section 2.2.
Urgency or safety priority
For urgency or safety priority the communication frequency cannot be selected; it is
automatically set to the pair frequency as set for the DSC frequency.
14. Do the following "How to set DSC frequency".
How to set DSC frequency
Routine priority
a) Rotate the ENTER knob to select DSC FREQ and then press the ENTER knob.
b) Rotate the ENTER knob to select appropriate DSC band and then press the ENTER
knob. One of the menus shown below appears depending on the band selected.
2MHz
4MHz
6MHz
c) Rotate the ENTER knob to select DSC frequency and then press the ENTER knob. The
screen shows the DSC frequency band selected, at DSC FREQ.
Urgency or safety priority
For urgency and/or safety priority, COMM FREQ is automatically set to the same pair
frequency as the DSC frequency.
a) Rotate the ENTER knob to select DSC FREQ and then press the ENTER knob.
5. ROUTINE MESSAGE CALLING, RECEVING
8MHz
12MHz
16MHz
2187.5 kHz
4207.5 kHz
6312.0 kHz
8414.5 kHz
12577.0 kHz
16804.5 kHz
18MHz
22MHz
25MHz
5-3