Receiving A Group Call - Furuno FS-5075 Operator's Manual

5. ROUTINE MESSAGE CALLING, RECEVING
Sending message by NBDP terminal unit
The message "STATION ENTRY COMPLETED FROM DSC. Press any key to escape."
appears on the screen of the NBDP terminal unit.
1. Press any key on the NBDP terminal unit to erase the message.
2. Press the function key F3 on the keyboard of the NBDP terminal unit to open the
Operate menu.
3. Select Call Station and then press the Enter key.
4. DSC is selected; press the Enter key. Connect appears in reverse video.
5. Type and transmit your message.
6. When you finished sending your message, press the function key F10 to disconnect the
line.
5.2.2

Receiving a group call

Group ID must be registered in order to receive a group call (see paragraph 6.15.3).
When a group call is received, the audio alarm sounds. The icon (
flashes in black and white, and the pop-up message "GROUP MSG received! [CANCEL]:
Stop alarm" appears.
1. Press the CANCEL key to silence the audio alarm. The pop-up message disappears.
2. Press the TAB key to select the
3. Press the ENTER knob.
4. Rotate the ENTER knob to select ACTIVE and then press the ENTER knob.
5. Watch on the working frequency. Communicate by radiotelephone or NBDP (see
"Receiving message by NBDP terminal unit" on next page). If there is the difference
between the registered frequency and used frequency to receive, the pop-up message
appears. Select Agree for the voice communication, or Disagree when you do not
change the frequency.
6. After you finish communicating, rotate the ENTER knob to select QUIT and then press
the ENTER knob.
7. Rotate the ENTER knob to select CONTINUE and then press the ENTER knob to finish
communication.
Receiving message by NBDP terminal unit
After receiving a group call, confirm the following.
• The control unit's screen shows "OCCUPIED" and the TX and RX frequencies.
• The message from the sending station appears on your NBDP terminal unit.
5-8
icon.
) on the tab area