Dsc Scan Screen - Furuno FS-5075 Operator's Manual

1. OPERATIONAL OVERVIEW
1.4

DSC Scan Screen

Press the SCAN key to show the DSC scan screen. This screen scans and receives the
distress and general frequencies.
1.5 How to Adjust LCD and Key Panel Brilliance
You can adjust the LCD and the key panel brilliance as follows:
1. Press the BRILL key to show the BRILL LEVEL SETUP window.
2. Press the 1 key to switch the DAY/NIGHT mode. The setting range depends on the
selected mode.
3. To adjust the LCD brilliance, rotate the ENTER knob or press the BRILL key.
4. To adjust the KEY panel brilliance, press the
5. Press the ENTER knob or CANCEL key to close the window.
Note: The window closes automatically when there is no operation for three seconds.
1.6 How to Turn On/Off the Main Speaker
You can turn the main speaker (other than DSC communication, error, and key beep) on/off.
1. Press the key to alternately disable or enable the main speaker.
2. When you set the speaker on, press the VOLUME/PWR knob to adjust volume of main
speaker (cw: volume up, ccw: volume down).
1-4
34°42 . 2800 ' N
135°19 . 5900 ' E
Speaker ON
WR2: The optional antenna for
the routine frequency
RX: Transceiver unit
Maximum six distress and
routine frequencies scanned.
or key.
Speaker OFF