Cornelius Enduro ED-250 BCP Installation Manual
Cornelius Enduro ED-250 BCP Installation Manual

Cornelius Enduro ED-250 BCP Installation Manual

Cornelius ice/beverage dispenser installation manual
Hide thumbs Also See for Enduro ED-250 BCP:

Advertisement

Installation Manual

ENDURO ICE/BEVERAGE DISPENSER
Model: ED-250 BCP
Publication Number: 620916501INS
Release Date: October 19, 2005
Revision Date: August 3, 2010
Revision: E
Visit the IMI Cornelius web site at www.cornelius.com for all your Literature needs.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Enduro ED-250 BCP and is the answer not in the manual?

Questions and answers

Summary of Contents for Cornelius Enduro ED-250 BCP

  • Page 1: Installation Manual

    Installation Manual ENDURO ICE/BEVERAGE DISPENSER Model: ED-250 BCP Publication Number: 620916501INS Release Date: October 19, 2005 Revision Date: August 3, 2010 Revision: E Visit the IMI Cornelius web site at www.cornelius.com for all your Literature needs.
  • Page 2: Contact Information

    Commercial Warranty. Cornelius will not be responsible for any repair, replacement or other service required by or loss or damage resulting from any of the following occurrences, including but not limited to, (1) other than normal and proper use and normal...
  • Page 3: Table Of Contents

    Safety Instructions ............1 Read And Follow All Safety Instructions .
  • Page 4: Safety Instructions

    Only trained and certified electrical, plumbing and refrigeration technicians should service this unit. ALL WIRING AND PLUMBING MUST CONFORM TO NATIONAL AND LOCAL CODES. FAILURE TO COMPLY COULD RESULT IN SERIOUS INJURY, DEATH OR EQUIPMENT DAMAGE. Publication Number: 620916501INS AFETY NSTRUCTIONS Recognize Safety Alerts - 1 - © 2001-2010, IMI Cornelius Inc.
  • Page 5: Safety Precautions

    NOTE: Many units incorporate the use of additional equipment such as icemakers. When any addition equipment is used you must check with the equipment manufacturer to determine the additional weight the counter will need to support to ensure a safe installation. © 2004-2010, IMI Cornelius Inc. Enduro Ice/beverage Dispenser Installation Manual ARNING...
  • Page 6: Description

    Ice Storage: 250 pounds Maximum No. of Beverage Faucets Available Cold Plate (Built-in) Electrical 120/1/60, 3.5 Amps 30 in. Wide X 30-11/16 in. Deep X 39-5/8 Dimensions in. High Publication Number: 620916501INS - 3 - © 2001-2010, IMI Cornelius Inc.
  • Page 7: Installation Instructions

    3--wire power cord is provided. An adapter plug for the particular country will need to be provided by the Installer. © 2004-2010, IMI Cornelius Inc. Enduro Ice/beverage Dispenser Installation Manual (NSF) silastic sealant (Dow 732 or equal) approximately must pitch continuously downward and contain no “traps”...
  • Page 8: Figure 1:Parts Identification

    B. Connect the CO2 source line to dispenser inlet line labeled “CO2“. C. The dispenser regulator outlet pressure is factory preset to 34 psig  2 psig DO NOT ADJUST. Publication Number: 620916501INS Figure 1. Parts Identification - 5 - © 2001-2010, IMI Cornelius Inc.
  • Page 9: Adjust Water -To-Syrup Ratio

    5. Set a syrup flow adjuster to get the desired ratio. 6. Test the valve and adjust until a consistent ratio is delivered three consecutive times. 7. Repeat procedure for other valves. © 2004-2010, IMI Cornelius Inc. - 6 - Publication Number: 91971RINS...
  • Page 10: Figure 3: Mounting Template

    Enduro Ice/beverage Dispenser Installation Manual Figure 3. Mounting Template Publication Number: 620916501INS - 7 - © 2001-2010, IMI Cornelius Inc.
  • Page 11: Figure 4: Drip Tray Drain Assembly

    Enduro Ice/beverage Dispenser Installation Manual Figure 4. Drip Tray Drain Assembly © 2004-2010, IMI Cornelius Inc. - 8 - Publication Number: 91971RINS...
  • Page 12: Figure 5: Flow Diagram (Unit With Eight Faucets)

    Enduro Ice/beverage Dispenser Installation Manual FAUCETS VIEWED FROM THIS SIDE Figure 5. Flow Diagram (Unit With Eight Faucets) Publication Number: 620916501INS - 9 - © 2001-2010, IMI Cornelius Inc.
  • Page 13: Figure 6: Flow Diagram (Pneumatic Ice Gate)

    Enduro Ice/beverage Dispenser Installation Manual Figure 6. Flow Diagram (Pneumatic Ice Gate) © 2004-2010, IMI Cornelius Inc. - 10 - Publication Number: 91971RINS...
  • Page 14: Figure 7: Wiring Diagram (115 Volt Unit)

    BL AC K WH T WHITE YE LL OW ORAN GE BR N BR OWN VIOL ET BL U BL UE R ED R ED GRE EN GEN /YE L GRE EN W/YEL L OW STR IP © 2001-2010, IMI Cornelius Inc.
  • Page 15: Figure 8: Wiring Schematic (115 Volt)

    Enduro Ice/beverage Dispenser Installation Manual Figure 8. Wiring Schematic (115 Volt) © 2004-2010, IMI Cornelius Inc. - 12 - Publication Number: 91971RINS...
  • Page 16: Troubleshooting

    B. Gently tap on ice to break it loose. together). D. Restore CO2 supply to dispenser. dispenser. - 13 - EMEDY maker problems, consult icemaker manual. ice (see page 2, Unit Description). Check 24V transformers. tank pressure. tank pressure. fuse or circuit breaker. © 2001-2010, IMI Cornelius Inc.
  • Page 17: No Ice Dispensed From Manual Ice Dispense Push Button Switch

    C. Defective ice gate solenoid D. Defective portion controller. Contact your local syrup or beverage equipment distributor for additional information and troubleshooting of beverage system. © 2004-2010, IMI Cornelius Inc. Enduro Ice/beverage Dispenser Installation Manual ROBABLE AUSE E. Make sure that cover is “snapped” into installed.
  • Page 19 IMI Cornelius Inc. www.cornelius.com...

Table of Contents

Save PDF