230Vac, otherwise is 220Vac. When the switch No.3 is on the ON
side, the output frequency is 60Hz,otherwise is 50Hz. The inverter
must stop working when it be re-set the output frequency or voltage.
When the voltage level and the output frequency were set, the
inverter make sure that the voltage and frequency are consistent
with the bypass.
Switch Node
The inverter can be control by the other equipment through the
switch node. When the switch node is link, it equal to ON/OFF
switch is on. The connection between the switch node and the
ON/OFF switch as follow diagram:
ON/OFF
Switch
POS(+)
NEG(-)
If need to use the switch node, a relay should be used. The rating
current of the relay should not be less than 5A. The cross section of
2
wire needs 1mm
.
13