Troubleshooting The Installation - Cisco ASR-1000-SIP10 Hardware Installation Manual

Troubleshooting the Installation

This chapter describes how to troubleshoot the installation of SIPs and SPAs on the Cisco ASR 1000
Series Aggregation Services Routers. This chapter contains the following sections:
•
•
•
•
Troubleshooting
This section describes troubleshooting the installation of the SIPs and SPAs. Possible problems,
observations and comments, and solutions are indicated for the following troubleshooting symptoms:
•
•
SIP Transitions Repeatedly from On to Off
Possible Problem
SIP is booting up; this is
normal operation
SIP does not go beyond the
bootup stage
OL-14126-03
Troubleshooting, page 7-1
Using debug Commands, page 7-2
Packing a SPA for Shipment, page 7-3
Packing a SIP for Shipment, page 7-5
SIP transitions repeatedly from on to off
SIP is deactivated
Observations and Comments
SIP STATUS LED alternates
green, amber, or off
SIP STATUS LED transitions
continue and alternates green,
amber, or off
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Hardware Installation Guide
C H A P T E R
Solutions
Wait 30 seconds until the boot process completes and the
STATUS LED stays on.
Follow the recommended action for the displayed error
message.
7
7-1